11.5
Removing the fork legs
11.6
Installing the fork legs
11 SERVICE WORK ON THE CHASSIS
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to
the side.
Info
Do not activate the hand brake lever while the front
wheel is removed.
S01903-10
–
Unscrew screws
–
Unscrew screws
S01904-10
Main work
–
Position the fork legs.
Air release screw
the front.
Valve
A
Info
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
H01182-10
must be flush with the top edge of the upper triple
clamp.
The air suspension is located in the left fork leg. The
pressure and rebound damping is located in the right
fork leg.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
S01904-11
p. 53)
(
p. 103)
1
and take off the clamp.
2
and take off the brake caliper.
3
. Take out the left fork leg.
4
. Take out the right fork leg.
1
of the right fork leg is positioned to
of the left fork leg faces the front.
2
.
M8
17 Nm (12.5 lbf ft)
3
.
M8
12 Nm (8.9 lbf ft)
55