12 BRAKE SYSTEM
12.8
94
H02377-10
H02363-11
A00067-10
Checking the free travel of foot brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear
brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
–
5
Check that leaf spring
7
plate
in the brake caliper support are seated correctly.
–
Insert the new brake linings.
–
6
Mount pin
.
5
Leaf spring
engages in the groove on the pin.
Info
Always change the brake linings in pairs.
–
4
Mount cotter pins
.
–
Operate the hand brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
pressure point.
–
Add brake fluid up to level
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 (
p. 153)
–
2
Position cover
with membrane
–
Mount and tighten screws
Info
Clean up overflowed or spilled brake fluid immedi-
ately with water.
in the brake caliper and sliding
A
.
5 mm (0.2 in)
3
.
1
.