Preparing Vehicle For Rides On Wet Sand - Husqvarna TC 250 Owner's Manual

7 PREPARING FOR USE
7.5
28

Preparing vehicle for rides on wet sand

M01129-01
M01274-01
M01107-01
–
Check the radiator cap.
Value on the radiator cap
» If the indicated value does not correspond to the setpoint
value:
Warning
Danger of scalding During motorcycle
operation, the coolant gets very hot and is
under pressure.
–
Do not open the radiator, the radiator
hoses or other cooling system compo-
nents if the engine or the cooling system
are at operating temperature.
–
Allow the cooling system and the engine
to cool down before you open the radiator,
the radiator hoses or other components of
the cooling system.
–
In the event of scalding, rinse the area
affected immediately with lukewarm water.
–
Change the radiator cap.
–
Fit a waterproofing device on the air filter.
Waterproofing device for air filter (79006921000)
Info
Observe the fitting instructions for Husqvarna Motor-
cycles accessories.
–
Adjust the carburetor jetting and setting.
Info
The recommended carburetor tuning is available from
your authorized Husqvarna Motorcycles workshop.
1.8 bar (26 psi)