14.2
Installing the battery
14.3
Recharging the battery
Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Return batteries to your authorized Husqvarna Motorcycles dealer or dispose of them at a collection
point for used batteries.
(TX 300)
Main work
–
Position the battery in the battery compartment with the ter-
minals facing forward, and secure with holding bracket
Battery (HJTZ5S-FP) (
–
Mount and tighten screw
Guideline
Screw, battery sup-
port bracket
–
Connect positive cable
Guideline
Screw, battery termi-
nal
Contact disks
cable sockets
nal.
–
Slide positive terminal cover
H00388-10
–
Connect negative cable
Guideline
Screw, battery termi-
nal
–
Slide negative terminal cover
Finishing work
–
Mount the seat. (
–
Install the air filter box cover. (
(TX 300)
1 m (3 ft)
9 V
14 ELECTRICAL SYSTEM
p. 148)
2
.
M6
10 Nm (7.4 lbf ft)
5
to the battery.
M5
2.5 Nm (1.84 lbf ft)
A
must be mounted under screws
4
with the claws toward the battery termi-
6
over the positive terminal.
7
to the battery.
M5
2.5 Nm (1.84 lbf ft)
8
over the negative terminal.
p. 67)
p. 69)
1
.
3
and
111