Sata Drive Connection; Figure 4-12: Sata Drive Cable Connection - IEI Technology gKINO-DMF-421-R10 User Manual

gKINO-DMF SBC

4.8 SATA Drive Connection

The gKINO-DMF is shipped with a SATA drive cable. To connect the SATA drives to the
connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-12.

Figure 4-12: SATA Drive Cable Connection

Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-13.
Step 4: Connect the SATA power cable. Connect the SATA power connector to the
back of the SATA drive. See Figure 4-13. Step 0:
Page 61