IEI Technology gKINO-DMF-421-R10 User Manual page 65

gKINO-DMF SBC
WARNING:
The installation instructions described in this manual should be carefully
followed in order to prevent damage to the gKINO-DMF, gKINO-DMF
components and injury to the user.
Before and during the installation please DO the following:

Read the user manual:
o
The user manual provides a complete description of the gKINO-DMF
installation instructions and configuration options.

Wear an electrostatic discharge cuff (ESD):
o
Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.

Place the gKINO-DMF on an antistatic pad:
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.

Turn all power to the gKINO-DMF off:
o
When working with the gKINO-DMF, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before and during the installation of the gKINO-DMF DO NOT:

Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.

Use the product before verifying all the cables and power connectors are
properly connected.

Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
Page 51