Clear Cmos Button; And Sata2 Select Jumper; Figure 4-10: Clear Cmos Button Location - IEI Technology gKINO-DMF-421-R10 User Manual

gKINO-DMF SBC

4.6.2 Clear CMOS Button

If the gKINO-DMF fails to boot due to improper BIOS settings, use the button to clear the
CMOS data and reset the system BIOS information.
The location of the clear CMOS button (J_CMOS1) is shown in Figure 4-10

Figure 4-10: Clear CMOS Button Location

4.6.3 M.2 and SATA2 Select Jumper
Use the M.2 and SATA2 select jumper (MSATA_SW1) to set the priority of M2_KEY_B1
and S_ATA2 connectors since the M.2 (M2_KEY_B1) slot is co-lay with the SATA2
connector. The M.2 and SATA2 select switch settings are shown in Table 4-2.
Setting
Short
Open
Table 4-2: M.2 and SATA2 Select Switch Settings
The location of the M.2 and SATA2 select switch is shown in Figure 4-11 below.
Description
M.2 as the priority (Default)
(SATA2 will be disabled if an M.2 module is
installed in the M2_KEY_B1 slot.)
SATA2 as the priority
Page 59