GE C60 Instruction Manual page 223

5 SETTINGS
• PUSHBTN 1 MESSAGE: This setting controls the behavior of the user-programmable pushbutton that is programmed
in the and
PUSHBTN 1 ID PUSHBTN 1 ON TEXT
sage that is programmed in the
When set to "Disabled", user-programmable pushbutton messages do not display. Otherwise the on message displays
when the user-programmable pushbutton becomes activated, and if in the "Latched" mode the off message displays
when the user-programmable pushbutton becomes deactivated.
When set to "Normal", the duration the message displays is as specified by the
When set to "High Priority", the duration of the off message is as specified by the
on message is displayed as long as the user-programmable pushbutton is activated. While activated, target and other
messages are suppressed. To allow front panel keypad operation, when a keypad button is pressed the message is
supressed for 10 seconds.
• PUSHBUTTON 1 EVENTS: If this setting is enabled, each user-programmable pushbutton state change is logged as
an event into the event recorder.
The figures show the user-programmable pushbutton logic.
Figure 5–16: USER-PROGRAMMABLE PUSHBUTTON LOGIC (Sheet 1 of 2)
GE Multilin
settings, and the behavior of the user-programmable pushbutton off mes-
and
PUSHBTN1 ID PUSHBTN 1 OFF TEXT
C60 Breaker Protection System
5.2 PRODUCT SETUP
settings.
FLASH MESSAGE TIME
FLASH MESSAGE TIME
setting.
setting, but the
5
5-87