GE C60 Instruction Manual page 178

5.2 PRODUCT SETUP
The GSSE/GOOSE configuration main menu is divided into two areas: transmission and reception.

PATH: SETTINGS PRODUCT SETUP
 GSSE / GOOSE
 CONFIGURATION
The main transmission menu is shown below:

PATH: SETTINGS PRODUCT SETUP

TRANSMISSION
 TRANSMISSION

The general transmission settings are shown below:

PATH: SETTINGS PRODUCT SETUP
5
 
TRANSMISSION GENERAL
 GENERAL

The
DEFAULT GSSE/GOOSE UPDATE TIME
put state changes to be sent. When remote output data changes, GSSE or GOOSE messages are sent immediately. This
setting controls the steady-state heartbeat time interval.
The
DEFAULT GSSE/GOOSE UPDATE TIME
The GSSE settings are shown below:

PATH: SETTINGS PRODUCT SETUP
 
TRANSMISSION GSEE
 GSSE

These settings are applicable to GSSE only. If the fixed GOOSE function is enabled, GSSE messages are not transmitted.
The setting represents the IEC 61850 GSSE application ID name string sent as part of each GSSE message. This
GSSE ID
string identifies the GSSE message to the receiving device. In C60 releases previous to 5.0x, this name string was repre-
sented by the
RELAY NAME
5-42

COMMUNICATIONS
 TRANSMISSION

 RECEPTION
MESSAGE


COMMUNICATIONS
 GENERAL

 GSSE
MESSAGE

 FIXED GOOSE
MESSAGE

 CONFIGURABLE
MESSAGE
 GOOSE

COMMUNICATIONS
DEFAULT GSSE/GOOSE
UPDATE TIME: 60 s
sets the time between GSSE or GOOSE messages when there are no remote out-
setting is applicable to GSSE, fixed C60 GOOSE, and configurable GOOSE.

COMMUNICATIONS
GSSE FUNCTION:
Enabled
GSSE ID:
MESSAGE
GSSEOut
DESTINATION MAC:
MESSAGE
000000000000
setting.
C60 Breaker Protection System
 
IEC 61850 PROTOCOL GSSE/GOOSE CONFIGURATION
 
IEC 61850 PROTOCOL GSSE/GOOSE CONFIGURATION
 
IEC 61850 PROTOCOL GSSE/GOOSE CONFIGURATION
Range: 1 to 60 s in steps of 1
 
IEC 61850 PROTOCOL GSSE/GOOSE CONFIGURATION
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
5 SETTINGS
GE Multilin