Mid Power Chassis; High Power Chassis - Motorola MCS 2000 Service Instructions Manual

3-4
Part Number
R-1070A Shields and surface-mounted component -
(superseded by IC removal/rework station
R1319A)
R1319A 110VAC Surface-Mounted Device Rework Station
R1321A 220VAC
(supersedes R1070A)
6680332E82 R1319A/R1321A Reflow Nozzle
6680332E83 R1319A/R1321A Reflow Nozzle
6680332E84 R1319A/R1321A Reflow Nozzle
6685629A01 End Cutter
HLN6621 Plug, coaxial Mini UHF male connector.
Note: this connector is delivered with the
radio. Prior to installation, replace the RF
connector provided with the antenna with
this connector.
!
C a u t i o n

Mid Power Chassis

1. Place radio on bench with fins facing downward and away.
2. Remove the plastic cover. This position leaves the top side of the PC boards fully exposed
and the 18 pin connector (see
offset left of center.
3. Place the control head directly in front of the chassis with the control head and chassis sides
aligned to each other. The two 18 pin connectors MUST also be aligned. This means that the
control head is sitting upright.
!
C a u t i o n
4. With the colored side of the control head extender cable facing upward all the way between
the control head and the chassis connect the cable to both control head and chassis 18 pin
connectors.

High Power Chassis

1. Place radio on bench with fins facing downward and away.
2. Remove the polycarbonate cover. This position leaves the top side of the PC boards fully
exposed and the 18 pin connector (see
connector is offset right of center.
December 6, 2004
Test Equipment, Service Aids and Tools: Field Programming
Table 3-3. Recommended Service Tools
Description
Failure to follow these instructions may cause severe damage
to the control head.
Table 3-4) facing the operator. Note that the 18 pin connector is
If the cable is plugged in upside down the control head will
burn out.
Removal of surface-mounted integrated circuits
Removal of surface-mounted integrated circuits
For IC removal (approximate size 0.8 in. x 0.8 in.)
For IC removal (approximate size 0.6 in. x 0.6 in.)
For IC removal (approximate size 0.5 in. x 0.5 in.)
Extraction tool for removable control head but-
tons.
Recommended RF connector to interface with
MCS 2000 radios. For use during bench test and
tuning.
Table 3-4) facing the operator. Note that the 18 pin
Application
68P81083C20-D