Disassembly Of Control Head - Cm200 - Motorola RADIUS CM200 Basic Service Manual

2-10
6.7

Disassembly of Control Head - CM200

1. Disconnect the flat cable from the Control Head PCB connector. See Figure 2-11.
2. Remove the PCB from the keypad assembly.
3. Remove the LENs from the rubber keypad assembly.
4. Remove the keypad assembly from the control head housing by lifting it up from the face
side.
5. Disconnect the speaker socket and remove the speaker from the keypad assembly.
NOTE DO NOT touch or contaminate the conductive pads on the under side of the keypad
or the conductive contacts on the printed circuit board.
.
Speaker
Figure 2-11 Control Head Housing Removal CM200
Control Head Housing
Keypad Assembly
Lens
PCB
MAINTENANCE