Specifying Basic Test Settings - JDS Uniphase hst-3000 User Manual

Specifying
After you launch an application, you verify and specify test
settings using the configuration menus. The following proce-
basic test
dure describes how to access the test configuration menus
settings
and specify basic settings.
NOTE:
If you change settings while transmitting traffic, results will
not reflect the true state of the circuit. Always stop traffic
before changing settings.
To specify basic test settings
1 Launch an application and specify the test mode (see
2 Press the Configure navigation key.
Figure 17 Summary Settings Menu
HST-3000 Ethernet Testing User's Guide
"Launching an application" on page
The HST launches the application in the mode you speci-
fied, and the Summary Results screen appears.
The Summary Settings menu appears, listing the key
settings for the application you launched.
trates the settings for the Terminate 1G Optical Ethernet
application when running a Layer 3 Traffic test.
Chapter 1 Getting Started
Configuring your test
28).
Figure 17 illus-
35