Status Leds - JDS Uniphase hst-3000 User Manual

Table 6 Ethernet software options (Continued)
Option
IPv6 Traffic
MPLS Traffic

Status LEDs

Description
Using this option, you can transmit
and analyze IPv6 traffic in terminate
and monitor/through modes. The
Layer 4 TCP/UDP option is also
required for layer 4 IPv6 testing.
Using this option, you can specify up
to two MPLS labels for transmitted
traffic when testing and qualifying
core and metro networks.
Six status LEDs are located on the front of the HST-3000,
above the screen.
Table 7

Status LEDs

LED Description
Sync An LED that reports whether or not the link is active.
– Solid green indicates the link is active.
– If the Sync LED is not illuminated, the link is not
currently active.
Data An LED that reports the status of frame or packet
detection.
– Solid green indicates frames or packets have
been detected in the traffic stream.
– If the Data LED is not illuminated, frames are no
longer being detected.
Error An LED that reports error conditions.
– Solid red indicates an error. To determine the
type of error, observe the Summary result cate-
gory.
– If the Error LED is not illuminated, all Summary
results are OK.
HST-3000 Ethernet Testing User's Guide
Table 7 describes the status LEDs.
Chapter 1 Getting Started
Status LEDs
Catalog Number
HST3000-IPV6
HST3000-MPLS
7