Inserting Errors - JDS Uniphase hst-3000 User Manual

Inserting errors

d Press the Action soft key again, and then clear the
service disruption time by selecting Reset
Svc Disruption.
4 Initiate the switch to the protect line.
The HST-3000 measures service disruption time, and
displays the measurement as the Service Disrupt result
in the Statistics category.
You can use the HST-3000 to insert errors when you perform
end-to-end and loopback tests.
To insert errors
1 If you haven't already done so, launch the Terminate
application for the circuit you are testing (see
an application" on page
the appropriate procedure below).
– "Selecting a layer 2 test" on page 46
– "Selecting a layer 3 IP test" on page 120
– "Selecting a layer 4 TCP/UDP test" on page 165
– "Selecting a multiple streams test" on page 182
2 Initialize the link (see
testing" on page
3 If you are inserting pause frames into layer 3 or layer 4
traffic, establish an IPoE connection or a PPPoE session:
– If you are transmitting IPv4 traffic, see
IPoE connection for IPv4 traffic" on page
"Establishing a PPPoE session" on page
– If you are transmitting IPv6 traffic, see
IPoE connection for IPv6 traffic" on page
4 Press the Configure navigation key.
A configuration menu appears.
HST-3000 Ethernet Testing User's Guide
28), and then select a test (see
"Initializing the link for Ethernet
47).
Chapter 3 Ethernet Testing

Inserting errors

"Launching
"Establishing an
122, or
128.
"Establishing an
124.
81