Discovering An Instrument - JDS Uniphase hst-3000 User Manual

Discovering an
instrument
To discover another JDSU test instrument
1 Before testing, ensure that instruments on the subnet are
discoverable by doing the following for each:
a Launch a single-stream IPv4 terminate application
(see "Launching an application" on page
J-Connect is not available when running MAC-in-MAC,
multiple stream, or IPv6 applications.
b Press the Configure navigation key, then use the right
arrow key to display the Test Mode menu.
c Verify that the Unit Discoverable setting is Yes.
d Verify that a different source IP address is assigned to
each instrument.
2 Connect your instrument to the circuit, and then do the
following:
a Launch a single-stream IPv4 terminate application.
b Verify that the Sync and Data LEDs are illuminated,
indicating that an active link is established.
c On your instrument, press the Action soft key, and
then select Discover Units.
A message appears asking you to wait while the instru-
ment discovers devices.
If the instrument discovered other test instruments, their unit
identifiers appear on the Discovered Devices screen. A count
of the number of discovered devices also appears.
HST-3000 Ethernet Testing User's Guide
Using J-Connect to discover another JDSU test set
Chapter 1 Getting Started
28).
23