Running The Test - JDS Uniphase hst-3000 User Manual

Chapter 7 Automated RFC 2544 Testing
Running the Classic RFC 2544 test
Running the
test
210
– If OK is used to enable a setting, use the Accept soft key
to proceed to the next screen.
– Use Cancel to return to the previous screen.
– If you change a setting for an existing test configuration,
the unit will automatically prompt you to overwrite the
existing configuration or create a new configuration (using
the modified settings) by entering a new name.
– Use the Summary soft key to view the HST Setup screen
and review key settings for the test.
Before running the RFC 2544 test, verify that no other appli-
cations are running.
To run the Classic RFC 2544 test
1 Specify any settings that are not specified in the test. For
details, see "Understanding the external settings" on
page 209.
2 Press the AutoTest button.
A test menu appears, with softkeys that allow you to
display the ETH ELEC Scripts, ETH OPT Scripts,
IPv6 ELEC Scripts, or IPv6 OPT Scripts menu. The IPv6
menus only appear if you purchased the IPv6 software
option.
3 If necessary, use the left and right arrow key to display the
appropriate menu for the rate you are testing, and then
select the test.
A screen appears briefly indicating that the test is
launching, then the Choose Configuration menu appears.
The menu lists any existing test configurations and
provides options that allow you to create or delete config-
urations.
HST-3000 Ethernet Testing User's Guide