Transmitting a
With a constant load, the HST-3000 transmits frames contin-
constant load
uously with a fixed bandwidth utilization. You can specify the
load as a percent or a bit rate. See
Figure 21 Constant traffic
When you setup a constant traffic load, you can specify the
bandwidth as a percentage of the line rate or as a bit rate in
Mbps.
To transmit a constant load of traffic
1 If you haven't already done so, launch your application
2 Press the Configure navigation key.
3 Use the left and right arrow keys to go to the Traffic
HST-3000 Ethernet Testing User's Guide
Bandwidth
(configurable
either as%
or in Mbps)
(see
"Launching an application" on page
select your test (see the appropriate procedure below):
–
"Selecting a layer 2 test" on page 46
–
"Selecting a layer 3 IP test" on page 120
–
"Selecting a layer 4 TCP/UDP test" on page 165
A configuration menu appears.
configuration menu.
Chapter 3 Ethernet Testing
Configuring layer 2 Ethernet tests
Figure
21.
Time
28), and then
57