Sending Lbm Or Ltm Messages; Mac-In-Mac Testing - JDS Uniphase hst-3000 User Manual

Sending LBM or
LTM messages

MAC-in-MAC testing

To turn RDI or AIS analysis On
1 On the Main screen, press the Action soft key, then select
one of the following:
– Start Traffic (if you configured a constant, bursty, or
flooded load).
– Start Ramp (if you configured a ramped traffic load).
2 Press the Action soft key again, then select one of the
following.
– RDI On.
– AIS On.
3 Repeat step 2
The instrument transmits traffic, and monitors the circuit for
RDI or AIS. The instrument will continuously monitor the
circuit for each, and generate AIS until you turn them Off.
After you specify OAM settings, you can start traffic and send
LBM or LTM messages.
To send LBM or LTM messages
1 On the Main screen, press the Action soft key, then select
one of the following:
– Send LBM
– Send LTM
2 Repeat step 1
The instrument sends the message.
If you purchased the MAC-in-MAC option for your instrument,
a series of MAC-in-MAC (MiM) applications are available
which allow you to transmit and analyze unicast layer 2
HST-3000 Ethernet Testing User's Guide
if you want to turn on the other item.
if you want to send the other message.
Chapter 3 Ethernet Testing

MAC-in-MAC testing

105