Specifying The Traffic Mode And Ports - JDS Uniphase hst-3000 User Manual

Specifying the
traffic mode
and ports
Table 12 Well Known TCP/UDP Ports (Continued)
Service Name
NetMeeting T.120
NetMeeting User Location Service
NetMeeting User Location
Service ULS
NNTP
NNTP (SSL)
Radius accounting (Routing and
Remote Access)
Radius authentication (Routing and
Remote Access)
Remote Install TFTP
SNMP
SNMP Trap
Telnet
WINS NetBios over TCP/IP name
service
WINS Proxy
WINS Registration
WINS Replication
If you selected the Layer 4 Traffic test, before you transmit
traffic you must indicate whether the traffic will carry a TCP or
UDP header, and specify the source and destination port
numbers for the generated traffic.
Port 0 (zero) is reserved by TCP/UDP for networking; there-
fore, it is not available when you configure your traffic.
HST-3000 Ethernet Testing User's Guide
Chapter 5 TCP/UDP Testing
Configuring layer 4 traffic
TCP Port UDP Port
1503
522
522
119
563
1646 or
1813
1645 or
1812
69
161
162
23
137
137
137
42
169