Maintenance; Monitoring; Devices With Site Targets; Data With Modbus Analyzer - GE N60 Instruction Manual
Network stability and synchrophasor measurement system
Hide thumbs
Also See for N60:
- Instruction manual (666 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (602 pages)
Table of Contents
Advertisement
N60 Network Stability and Synchrophasor
Measurement System
Chapter 9: Maintenance
Maintenance
This chapter outlines monitoring, maintenance, repair, storage, and disposal of the hardware and software.
9.1 Monitoring
Devices and data can be monitored.
9.1.1 Devices with Site Targets
To view an overview of devices:
1.
Access the Site Targets item in the Online Window area, below the list of devices. It can take a few minutes for all
devices to be read.
2.
Acknowledge any messages for unaccessible devices. The Site Targets window opens when done.
9.1.2 Data with Modbus Analyzer
Use the Modbus Analyzer under Maintenance > Modbus Analyzer to monitor the values of the UR device. Use the Modbus
memory map addresses outlined in the UR Family Communications Guide for the entries.
The upper part of the window displays values. The lower part of the window is for factory service use.
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
Figure 9-1: Site Targets window
9-1
Advertisement
Table of Contents
