GE N60 Instruction Manual page 577

APPENDIX D: MISCELLANEOUS
Page Description
--- Updated Synchrocheck content including settings, logic diagram, actual values, and number of elements from four to six in
interface chapter, FlexLogic operands table, settings, actual values, FlexAnalog table, features per product table, Modbus
memory map, IMD tables
--- Added (Source) Voltage Harmonics and THD Metering content to description, specifications, actual values, FlexElements table,
Modbus memory map, IMD table
--- Added Source Current THD and Harmonics content to specifications, actual values, Modbus memory map
--- Added Ground Instantaneous Overcurrent (IOC) content in description, specifications, FlexLogic operands table, settings,
features per product table, Modbus memory map, IMD table
--- Added Ground Time Overcurrent (TOC) content in description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Added Neutral Directional Overcurrent content in description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Added Neutral Instantaneous Overcurrent (IOC) content in description, specifications, FlexLogic operands table, settings,
features per product table, Modbus memory map, IMD table
--- Added Phase Directional Overcurrent content in description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Added Phase Time Overcurrent content in description, specifications, FlexLogic operands table, settings, features per product
table, Modbus memory map, IMD table
2-3 Updated Figure 2-1 Single-Line Diagram, including addition of new elements 50G, 50N, 51G, 51N, 51P, 67N, 67P
2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines
4-30 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter
5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port
5-49 Updated IEC 61850 section
5-142 Added FlexCurves section as per inclusion for N60 in Modbus memory map
5-182 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section
5-208 Added FlexCurves section and content
9-1 Added Monitoring section
9-2 Added Retrieve Files section
C- Added Command Line Interface appendix
Table D-5: Major changes for N60 manual version AB2 (English)
Page Description
--- Updated document throughout, including numbers of elements and FlexLogic operands table
--- Added EAC compliance information throughout, including logo on title page, rear panel, added specifications, added life
expectancy and decommissioning, added sections on Repairs, Storage, and Disposal
--- Updated several figures for consistency
2-13 Added UR Signal Processing section
5- Updated IEC 61850 content
A- Updated FlexAnalog table
Table D-6: Major changes for N60 manual version AB1 (English)
Page Description
--- Updated document throughout and put into new template. Major revision.
--- Updated references to digital inputs/outputs to contact inputs/outputs for consistency
--- Added content for advanced IEC 61850, for example in the Settings and Actual Values chapters
--- Added User-Programmable Fault Report function to chapters, including Settings, Actual Values, Commands and Targets
2- Updated Order Codes and Specifications
5-28 Added RS232 Baud Rate setting to Serial Ports section. Baud rate is now configurable, with two options.
5-32 Added Far-End Fault Indication (FEFI) section
9-2 Added Software Upgrade section to the Maintenance chapter
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
REVISION HISTORY
D
D-3