Transducer Inputs And Outputs; Records; User-Programmable Fault Reports; Event Records - GE N60 Instruction Manual

RECORDS

6.4.15 Transducer inputs and outputs

ACTUAL VALUES  METERING  TRANSDUCER I/O DCMA INPUTS  DCMA INPUT xx
 DCMA INPUT xx

Actual values for each DCmA input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value followed by the programmed units.
ACTUAL VALUES  METERING  TRANSDUCER I/O RTD INPUTS  RTD INPUT xx
 RTD INPUT xx

Actual values for each RTD input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value.
6.5 Records

6.5.1 User-programmable fault reports

ACTUAL VALUES  RECORDS  USER-PROGRAMMABLE FAULT REPORTS
 USER-PROGRAMMABLE
 FAULT REPORTS
6
This menu displays the user-programmable fault report actual values. See the User-Programmable Fault Report section in
chapter 5 for information on this feature.

6.5.2 Event records

ACTUAL VALUES  RECORDS  EVENT RECORDS
 EVENT RECORDS

The event records menu shows the contextual data associated with up to the last 1024 events, listed in chronological
order from most recent to oldest. When all 1024 event records have been filled, the oldest record is removed as a new
record is added. Each event record shows the event identifier/sequence number, cause, and date/time stamp associated
with the event trigger. See the
Only major output operands generate events, not every operand. Elements that assert output per phase, for example, log
operating phase output only without asserting the common three-phase operand event.
See also the system log (syslog) information in the previous chapter.
6-26
DCMA INPUT xx

0.000 mA
RTD INPUT xx

-50 °C
NEWEST RECORD

NUMBER: 0
LAST CLEARED DATE:

2002/8/11 14:23:57
LAST REPORT DATE:

2002/10/09 08:25:27
EVENT: XXX

XXX

EVENT: 3

POWER ON
EVENT: 2

POWER OFF
EVENT: 1

EVENTS CLEARED

COMMANDS  CLEAR RECORDS
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
Date and time stamps
EVENT 3
 
DATE: 2000/07/14
EVENT 3

TIME: 14:53:00.03405
menu for clearing event records.
CHAPTER 6: ACTUAL VALUES