GE N60 Instruction Manual page 325

CHAPTER 5: SETTINGS
— This setting determines if a client can write to the reserve bit. When the assigned FlexLogic
R-SV CB1 CLIENT CONTRL
operand is a logic 1 state, remote clients can write to both the reserve bit and the SvEna bit. When the FlexLogic operand
is a logic 0 state, the remote client writes to the reserve bit, the SvEna is rejected by the UR, and a negative response with
the appropriate Service Error is returned to the client.
— This setting sets the default state of the stream (On or Off) on power-up or restart.
R-SV CB1 SVENA DFLT
— The relay increments the Configuration revision every time the configuration is changed. This setting
R-SV CB1 CONFREV
allows the user to reset the configuration back to 1 or a value from 1 to 4294967295.
— A value from 0 through 7. The default value is 4.
R-SV CB1 PRIORITY
— The value represents the IPv4 Differentiated Services (formerly called TypeOfService) value. The
R-SV CB1 DSCP CLASS
default value is set for Expedited Forwarding (101110B (46 or 2EH). This value provides priority routing, when supported in
the routers.
— A range of values limited from 0 to 4095.
R-SV CB1 VLAN ID
— This setting allows the selection of a specific application ID for each sending device.
R-SV CB1 APPID
— This is the destination multicast IP address that is entered in Standard IPV4 address format. The valid
R-SV CB1 DEST IP
range for IPv4 is from 224.0.0.0 to 239.255.255.255. The UR does not test the address entered.
— This setting selects the level of security and authentication used, as outlined in the following table,
R-SV CB1 SECURITY
and is in the form of an enumeration as per standard. The range is 0 to 2.
Shaded settings in the table are not supported in firmware 7.0.
Table 5-22: Security
Enumeration Authentication
0 No
1 Yes
2 Yes
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
Figure 5-86: Logic for setting SvEna control bit
Encryption
No
No
Yes
SYSTEM SETUP
5
5-165