Setting Up Inputs/Outputs; Selecting Error Handling - GE DigitalFlow GF868 Programming Manual

Chapter 1. Programming Site Data

1.9 Setting Up Inputs/Outputs

Set up the GF868's inputs and outputs using the four options in the
instructions, refer to Figure 12 on page 88.
•
ERROR - program the meter's response during an error condition
•
- set up the
OPTN Slot 0
•
- set the meter's zero point cutoff value
ZERO
•
T,P - set up the temperature and pressure inputs
Enter the submenu by pressing
I/O
option.
Note: In this section, a slot's number will appear on the option bar only if an option card is installed in that slot. The
generic designations
to select it.
Proceed to the appropriate section to program the option selection made at the above prompt. Remember to record all
programmed data in Appendix B, Data Records.

1.9.1 Selecting Error Handling

This menu option permits programming of the manner in which the Model GF868's totalizers respond during an error
condition. See Chapter 2, Error Codes and Screen Messages, of the Service Manual for a discussion of the built-in
error codes.
1. At the I/O prompt, press [F1] = Error.
2. Press [F1] if you want the GF868 to Hold the last "good" reading and continues to totalize, based on that reading, or
press if you want the meter to stop totalizing.
[F2], No Up,
14
analog outputs and any option cards
at the initial User Program screen. Then press
[F4]
Slot x and Fx are used to indicate any one of the expansion slots and the function key used
submenu. While following the programming
I/O
[F1]-[F4]
DigitalFlow™ GF868 Programming Manual (1-Channel)
to select the desired
I/O