Table of Contents
Advertisement
Section 2: Service Guidelines
2.4
General Maintenance
DESCRIPTION
Fans
External Projector
Covers
Air vents are located around the projector to keep it at a consistent operating temperature. Make sure that the
empty space around these vents ("stay out zone") is within the limits specified in
will prevent the blockage of air flow and prevent overheating. The projector is equipped with active thermal
monitoring. The speed of the cooling fans will adjust to the projector temperature.
• Do not put the projector on a radiator or heat register.
• Do not put the projector in an enclosure without correct ventilation.
• Do not put objects into the ventilation openings of the projector. They can touch dangerous voltages or short-
circuit components resulting in a fire or shock hazard.
• Do not spill liquids into the projector. If a spill occurs, immediately disconnect the projector and have it
serviced by a Christie accredited service technician.
2.5
Replace the Light Module
The light module is a non-serviceable part of the projector and must be replaced.
2-6
FREQUENCY
As required
Remove the fan from the projector, as outlined in the removal procedure
for each specific fan.
Use compressed air to blow particles off of the fan and away from the
projection unit.
As required
Before cleaning the modules, it is recommended that you install the lens
cap. This will keep dust particles from settling on the glass surface of the
lens.
Clean dust from external covers using a clean, lint-free cotton cloth as
required.
Do not service the projector while it is still connected. There are exposed
voltages that could cause severe physical injuries and possibly death. Always
power down and disconnect/disengage all power sources to the projector
before servicing or cleaning.
HOW TO CLEAN
Section 5
Entero RPMSP/RPMWU/RPMHD-LED01 Service Manual
Specifications. This
020-100368-05 Rev. 1 (06-2012)
Advertisement
Table of Contents
Troubleshooting
