7: Service Menu; Color Primary Settings - Christie Entero RPMWU-LED01 Service Manual

7 Service Menu
The service menu is accessible only by password:
• Main Menu > Configuration
The service menu items give the service technician more control
over individual projector settings than is available to the user.
7.1

Color Primary Settings

• Service Menu > Color Primary Settings
This menu contains information about the native LED colors that the
projector needs in order to match colors when Bright/ColorLOC is
turned OFF (see
NOTE: These values are factory-set and should NOT be changed
unless the projector is not operating correctly with ArrayLOC
turned OFF.
To update values:
1. Bright/ColorLOC must be turned OFF by selecting:
• ArrayLOC Configuration > Bright/ColorLOC Mode =
Off
2. Color adjustment must be disabled by selecting:
• Color Saturation > Select Color Adjustment = Max
Drives
3. LED brightness should be set to native or the preferred
projector by selecting:
• Advanced Color Adjustment > Color Mode = Native
4. Go to: Service Menu > Color Primary Settings
a. When the red menu items are selected a red test pattern
should appear. If not, select Auto Color Enable. Measure
its color and update the values.
b. Repeat the measurement for the green, blue and white
colors.
5. Color adjustment can be re-enabled by selecting:
• Main Menu > Configuration > Service > Color Saturation > Select Color Adjustment and choosing
any other option other than Max Drives.
Entero RPMSP/RPMWU/RPMHD-LED01 Service Manual
020-100368-05 Rev. 1 (06-2012)
7.10 ArrayLOC Service).
Figure 7-1 Color Primary Settings
7-1