Projector Does Not Power On; Light Module Suddenly Goes Off - Christie Entero RPMWU-LED01 Service Manual

Table 3.2 Error Codes (Continued)
Projector Head Module (PHM) Sensors
SP
Electronics Module (EM) Sensors
SE
Miscellaneous
PR
3.5

Projector Does Not Power ON

• Make sure that the projector is plugged in.
• Make sure that all cables are connected and not damaged.
3.6

Light Module Suddenly Goes OFF

• Check the shutter setting - if status display shows SH then the shutter is active. Toggle through shutter
modes. In gray shutter mode, it is possible to display menus.
• Verify that the RGB Brightness is set sufficiently higher than zero to make sure there is a visible image. The
DMD may be overheated. Check for an alarm condition.
Entero RPMSP/RPMWU/RPMHD-LED01 Service Manual
020-100368-05 Rev. 1 (06-2012)
01 PHM FD sensor 1 overtemp (not connected)
02 PHM FD Air inlet overtemp or sensor not functioning
03 PHM QDPC board overtemp or sensor not functioning
04 PHM FD DMD overtemp or sensor not functioning
05 PHM QDPC board overtemp or sensor not functioning
06 LM Air inlet overtemp or sensor not functioning
07 LM Air exhaust over temp or sensor not functioning
08 LM Power supply overtemp or sensor not functioning
09 LM LED Driver overtemp or sensor not functioning
10 LM ambient overtemp or sensor not functioning
11 LM Red thermistor overtemp or sensor not functioning
12 LM Green thermistor overtemp or sensor not functioning
13 LM Blue thermistor overtemp or sensor not functioning
14 LM IR thermistor overtemp or sensor not functioning
01 EM Inlet
02 Panel Driver Temperature
03 Image Processor Temperature
04 Option Card 1 Temperature
05 Option Card 2 Temperature
06 Option Card 3 Temperature
07 Option Card 4 Temperature
01 EM/PHM Firmware mismatch; upgrade required
02 Image processor card is missing or not seated correctly
Section 3: Troubleshooting
3-5