Capacities; System Voltage; Hydraulic System; Drive Motor Torque Hub (Gear Oil) - JLG 10msp Service And Maintenance Manual

SECTION 1 - MACHINE SPECIFICATIONS

1.1 CAPACITIES

System Voltage

• 24 V DC

Hydraulic System

• 5 qts U.S. (4.7 L)

Drive Motor Torque Hub (Gear Oil)

• 10 oz (296 cc)

1.2 COMPONENT DATA

Hydraulic Pump/Pump Motor Assembly

• Pump Motor - 24 V DC motor, Standard Duty
• Pump Displacement - 0.098 cu. in./rev. (1.6cc/rev.)
• Pump Output (Max.) - 2.25 gpm @ 1400 psi @ 24 V and
105 A @ 43 centistrokes (200 SSU)
• Reservoir Capacity - 1 gal (3.78 L)

Rear Wheel Drive Motors

• Drive Motors - 24 Volt DC, Variable
• Torque Hub - 3500 in.lb. (395.5 Nm) - Continuous Output
7000 in.lb. (791 Nm) - Intermittent Output
30.68:1 Gear Ratio
• Brakes - Friction Disk - Spring Applied - Electrically Released

Batteries/Battery Charger

• Batteries - 6 V DC (4 in series @ 24 V)
12 V DC (2 in series @ 24 V) (if equipped)
• Nominal Capacity - 12 V - 100 Amp Hour @ 20 Hour
6 V - 210 Amp Hour @ 20 Hour
• Type - M2 Marine Combination (AGM)/Valve Regulated/
Leak Proof/NonCorrosive/Maintenance Free
• Weight -12V - 65.7 lb (29.8 kg) per battery
6V - 64 lb (29 kg) per battery
1-2
JLG MACHINES EQUIPPED WITH DELTA Q BATTERY CHARGERS ARE DESIGNED
FOR THE BEST PERFORMANCE WITH OEM FACTORY APPROVED BATTERIES.
APPROVED JLG REPLACEMENT BATTERIES ARE AVAILABLE THROUGH JLG' S
AFTERMARKET PARTS DISTRIBUTION CENTERS OR JLG' S AFTERMARKET PRO-
GRAMS. FOR ASSISTANCE WITH PROPER BATTERY REPLACEMENT, PLEASE
CONTACT YOUR LOCAL JLG SUPPORT OFFICE.
BATTERIES APPROVED BY JLG HAVE BEEN TESTED FOR COMPATIBILITY WITH
THE ALGORITHM PROGRAMMING OF THE DELTA Q BATTERY CHARGER TO
OPTIMIZE BATTERY LIFE AND MACHINE C YCLE TIMES. THE USE OF NON
APPROVED BATTERIES IN YOUR JLG EQUIPMENT MAY RESULT IN PERFOR-
MANCE ISSUES OR BATTERY CHARGER FAULT CODES. JLG ASSUMES NO
RESPONSIBILITY FOR SERVICE OR PERFORMANCE ISSUES ARISING FROM THE
USE OF NON APPROVED BATTERIES.
• Battery Charger -
Microprocessor Controlled/SCR Circuit Monitor
120/240 Volt A.C. Selectable / 50/60 Hz input
24 volt, 20 amp output - with 2 amp finish
Reset Circuit Breaker
Automatic Charge Circuit
Plug Interlock Circuit
NOTE: These batteries require approximately five hours to fully
charge when drained to 80% discharge (only the RED LEDS
on platform console lit).

1.3 PERFORMANCE DATA

Platform Capacity

Table 1-2. Platform Maximum Capacity
SPECIFICATION
Platform
ANSI/CSA
CE 350 lb
(Indoor Use Only) (160 kg)
AUS
(Indoor Use Only)
NOTE: Distribute weight evenly in platform and material tray
when loading. Reference the capacity decal located on the
machines mast cover in the operators platform.

Maximum Horizontal Manual Side Force

Platform fully extended with maximum load
• ANSI/CSA: 100 lb (445 N)
• CE/AUS/JPN: 45 lb (200 N)
– JLG Lift –
MAXIMUM CAPACITY
Manual Powered
Carry Deck
Material Tray Material Tray
250 lb 200 lb 250 lb
(115kg) (90 kg) (115 kg)
MAX. WIND
SPEED
28 mph
(12 m/s)
0 m/s
0 m/s
3121228