Network Speed Dome·Quick Start Guide
Lock Screw
Lock Screw
Figure 2-9 Install the Speed Dome to the Bracket
8. Remove the protective film on the bubble after the installation is finished..
2.1.2 In-ceiling Mounting
Note:
In-ceiling mounting is only supported by indoor speed dome models of Type I.
Before you start:
The height of the space above the ceiling must be more than 250 mm.
The thickness of the ceiling must range from 5 mm to 40 mm.
The ceiling must be strong enough to withstand more than four times the weight of
the speed dome and the accessories.
Steps:
1. Rotate the bubble counterclockwise to separate it from the back box.
2. Remove the protective lens cover, foam, and sticker from the dome drive.
3. Install the memory card.
4. Attach the bubble to the back box, and rotate clockwise to secure it.
Protective Foam
Back Box
Bubble
Protective Sticker
Figure 2-10 Remove the Protective Accessories
9