Table of Contents
Advertisement
Figure 2-9 Fix the Camera to the Ceiling
Note:
In the supplied screw package, both self-tapping
screws and expansion blots are contained.
If the ceiling/wall is cement, expansion blots are
required to fix the camera. If the ceiling/wall is
wooden, self-tapping screws are required.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the surveillance angle.
1)
Loosen the No.1 adjusting screw to adjust the pan
position [0° to 360°].
2)
Tighten the No.1 adjusting screw.
3)
Loosen the No.2 adjusting screw to adjust the
tilting position [0° to 90°].
4)
Tighten the No. 2 adjusting screw.
5)
Loosen the No.3 adjusting screw to adjust the
rotation position [0° to 360°].
6)
Tighten the No.3 adjusting screw.
Ceiling/Wall Mounting with Junction Box
2.2.2
Note:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole in the
ceiling/wall according to the holes of drill template.
3. Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box' cover.
4. Fix the camera on the junction box's cover with
three supplied screws.
5. Secure the junction box's body with supplied screws
on the ceiling/wall.
Figure 2-11 Install the Junction Box
Figure 2-10 3-Axis Adjustment
Advertisement
Table of Contents
