Table of Contents
Advertisement
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
Ceiling/Wall Mounting with Junction Box
2.2.2
Before you start:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole (optional) in the
ceiling/wall according to the holes of the drill
template.
Figure 2-13 Drill Template of the Junction Box
Note:
Drill the cable hole, when adopting ceiling outlet to
route the cable.
3. Refer to step 3 of 2.2.1 Ceiling/Wall Mounting
without Junction Box to take out the camera's main
body.
4. Take apart the junction box, and align the screw
holes of the camera with those on the junction
box's cover.
5. Fix the camera's mounting base on the junction
box's cover with three PM4 × 10 screws.
Figure 2-14 Secure Screws on Junction Box's Cover
6. Secure the junction box's body on the ceiling/wall
with four PA4 × 25 screws.
Figure 2-15 Secure the Junction Box's Body on Wall
7. Combine the junction box cover with its body with
supplied screws on the junction box's cover.
/Ceiling
Junction
Box Body
Advertisement
Table of Contents
