Table of Contents
Advertisement
3. Install the memory card.
4. Align the cuts on the bubble with the lock screws on the back box to reinstall the
bubble. Tighten the lock screws.
5. Refer to steps 6 in section 2.1.1 Wall Mounting to install the bracket.
6. Install the speed dome to the bracket.
1). Hook the back box of the speed dome to the bracket with the safety rope. Route
the cables through the bracket.
2). Connect the corresponding cables.
3). Loosen the two lock screws on the bracket.
4). Install the speed dome to the bracket. Rotate the speed dome clockwise tightly.
5). Secure the two lock screws with the wrench.
Network Speed Dome·Quick Start Guide
Memory Card Slot
Open Cover
Figure 2-23 Install the Memory Card.
Figure 2-24 Hang the Safety Rope
15
Debug
Reset
Memory Card Slot
Advertisement
Table of Contents
