Table of Contents
Advertisement
3). Attach the bubble to the back box, and rotate clockwise to secure it.
4). Use the mounting base as a template to mark four screw holes onto the ceiling.
5). If you route cables from the top of the back box, mark the cable hole on the
ceiling and drill a hole.
6). Secure the mounting base to the ceiling with the set screws.
Cable Hole
7). Route the cables for the speed dome. Align the bottom of the speed dome with
the mounting base.
8). Line up the direction of arrow with the spring end of the mounting base.
9). Push the speed dome upwards and then forwards in the direction of the arrow.
When the speed dome is placed in position, the spring will automatically snap
into the lock clip firmly as shown in Figure 2-20.
Figure 2-20 Attach the Back Box to the Mounting Base
4. Remove the protective film on the bubble after the installation is finished.
Network Speed Dome·Quick Start Guide
Screw Holes
Figure 2-19 Secure the Mounting Base
Line up
13
Push Forwards
Push Upwards
Advertisement
Table of Contents
