Table of Contents
Advertisement
6. Install the bracket.
1). Drill four screw holes in the wall according to the holes on the bracket, and then
insert four M8 expansion screws into the mounting holes.
2). Attach the gasket and the bracket to the wall by aligning the four screw holes on
the bracket with four expansion screws on the wall.
3). Secure the bracket with four hex nuts and washers.
7. Install the speed dome to the bracket.
1). Hang the safety rope to the speed dome and the hook on the bracket as shown
in Figure 2-8.
2). Route the speed dome cables through the bracket.
3). Connect the corresponding cables.
4). Loosen the two lock screws on the bracket.
5). Install the speed dome to the bracket. Rotate the speed dome clockwise tightly.
6). Secure the two lock screws with the wrench.
Network Speed Dome·Quick Start Guide
Figure 2-7 Secure the Bracket
Figure 2-8 Hang the Safety Rope
8
Safety Rope
Advertisement
Table of Contents
