Installing Type Ii Speed Dome; Wall Mounting - HIKVISION UD06820B Quick Start Manual

2.2 Installing Type II Speed Dome

Wall Mounting

Notes:
 For cement wall, you need to use the expansion screw to fix the bracket. The
mounting hole of the expansion pipe on the wall should align with the mounting
hole on the bracket.
 For wooden wall, you can just use the self-tapping screw to fix the bracket.
 Make sure that the wall is strong enough to withstand more than eight times the
weight of the speed dome and the accessories.
 The bracket in Figure 2-7 is the recommended bracket for this series of speed dome,
and a pendent adapter is required if any other bracket is selected. The dimension of
pendant adapter is G1
Steps:
1. Loosen the four lock screws on the speed dome flange as shown in Figure 2-21.
Note:
Do not remove the lock screws from the speed dome.
2. Pull the bubble to separate it from the back box, and remove the protective foam,
sticker and lens cover from the dome drive.
Back Box
Network Speed Dome·Quick Start Guide
1
.
2
Figure 2-21 Loosen the Lock Screws
Lens Cover
Protective Foam
Figure 2-22 Remove the Protective Accessories
Lock Screws
Bubble
14
Sticker