Table of Contents
Advertisement
2). Remove the in-ceiling bracket as shown in Figure 2-16.
3). Install four bolts to the screw holes as shown in Figure 2-17.
2. Route the cables. The cables of speed dome can be routed either from the top or the
side of the back box, as shown in Figure 2-18. For the cables routed from the top of
the back box, it is required to drill a cable hole in the ceiling.
3. Install the speed dome.
1). Rotate the bubble counterclockwise to separate it from the back box.
2). Remove the protective lens cover, foam, and sticker from the dome drive.
Network Speed Dome·Quick Start Guide
Figure 2-16 Remove the Bracket
Figure 2-17 Install the bolts
Figure 2-18 Cabling for Ceiling Mounting
12
Advertisement
Table of Contents
