Programming T-540/Plus Telephones - golmar NEXA User Manual

AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED DOOR PANEL
PROGRAMMING THE TELEPHONES
Programming T-540 Plus telephones:
From sound module:
Locate the SW2 DIP switch situated on the top left-hand side of the back of the EL632/PLUS module
and set number 2 to ON. The door panel will reproduce a sound to advise that the system has entered
into programming mode.
In systems with more than one door panel, the programming process shall be done on the master door
panel only.
From coded module:
Press the key button three times and then enter the administrator pin he
(1)
Bear in mind the number of digits in the configured code (factory setting 2718 = 4).
Important: Programming from coded module:
- With EL632/PLUS and EL642/PLUS sound module V03 or later.
- With N3301/AL or NX3301 V03 or later.
To programme the telephone from a general entrance door panel (if any), see p. 106.
SW1
1 2
P3
1 0
M
ON
CN1 P1
SW1
P3
ON
P3
P2
S
ON
CN1 P1
P3
P2
SI
ON
CN1 P1
P3
P2
Each apartment must only have one master unit; if there are parallel units, whether monitors or telephones, they must be
configured as slaves.
Make a call to check that the telephone has been successfully programmed. Programme the other
telephones in the same way.
1 0
Once the programming has finished, set the
key if the programming is from coded module. If this is not done, the door panel will emit tones to
C
indicate that the system is still in programming mode
Key button + key button + key button + administrator pin.
Open the telephone to be programmed (see p. 104). In the SW1 DIP switch,
1 2
P3
select the P2 button function mode (see p. 103) and then press the P3
programming button.
ON
To show that the system is ready for programming, the door panel and the
telephone handset will emit a number of tones (the LED on the telephone will
P3
light up), enabling audio communication to be established with the door panel.
ON
Enter the code of the telephone to be programmed, followed by the key button.
P3
At this moment, the door panel and the handset will emit a number of tones
(the LED on the telephone will blink slowly).
To programme the telephone as the
will go out). Close the telephone.
To programme the telephone as the
CN1 P1 LED will blink rapidly), and then press the hang up button (the LED will go out).
SW1
ON
P3
Close the telephone.
P2
To programme the telephone as the
CN1 P1 button (the LED will blink rapidly), and then press the hang up button (the LED
SW1
ON
P3
will go out).
P2
Close the telephone.
, t module will emit tones
2 7 1 8
, press the hang up button (the LED
Master
, press the P1 lock release button (the
Slave
+
Slave
sound module programming switch to OFF
(programming from sound module)
:
(1)
, press the P2 function
Intercom
or press the
.
105