golmar NEXA User Manual page 144

AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL WITH DISPLAY
PROGRAMMING THE DOOR PANEL
Continued from previous page
R sident list menu: e
José Pérez
INSERT
MODIFY
DELETE
DELETE ALL
MODIFY
DELETE
DELETE ALL
SEND BOOKMARK
SENDING...
0056/0100
DELETE
DELETE ALL
SEND BOOKMARK
RECEIVE BOOKMARK
RECEIVING...
IMPORTANT: The transfer of entries can only be performed between two points.
During transmission, it is normal for other devices connected to the system to enter
DELETE ALL
SEND BOOKMARK
RECEIVE BOOKMARK
BUS TEST
Press
0001/0100
003409
029105
The message DELETING... will be displayed on the screen for a few
To end the process, press
DELETING...
Enables all entries in the RESIDENT LIST to be deleted. Press
Note: Once entries are deleted, they cannot be recovered.
Enables resident list data to be sent to another door panel or the guard
To start sending, press
After this operation, the devices will exit the configuration menu.
Enables resident list information to be received from another door panel
To start receiving, press
Before reception, the device deletes the contents of the resident list and
After transfer, the devices will exit the configuration menu.
0056
DO NOT set more than one device to reception or sending mode.
random operation (call reception, door opening,
Enables a test of the monitors associated with the contacts in the
To start the process, press
and the first position in the resident list will appear: if there are
no entries, the screen will show the message RESIDENT LIST EMPTY.
Use the scroll arrows to find the contact that requires deleting and
confirm by pressing .
seconds and then the following contact will appear. Repeat the process
to delete as many contacts as required.
start the process. When the message CONFIRM DELETION appears,
press to confirm or
unit of the same system. Before sending, the receiving device must be
in reception mode (see following section).
SENDING... and the sending record number.
or the guard unit of the same system.
(see above). The screen will show the message RECEIVING... and the
reception record number.
displays the message DELETING...
resident list to be carried out. Look through the resident list and check
that the associated monitor is connected and ready to receive calls.
.
to cancel the process.
. The screen will show the message
and set the sending device to sending mode
etc.)..
.
144
to