golmar NEXA User Manual page 89

AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED DOOR PANEL
PROGRAMMING THE DOOR PANEL
Programming fields:
Continued from previous page
Field "7": Configure the identification ID of the access control module.
Allows an identification code (ID) to be configured for the access control module.
Note: Possible identification codes (ID): "000" to "999".
( Step 1)
0 0
( Step 2)
( Step 3)
8
( Step 4)
Field "8": Configure field depth.
Allows the number of digits in the calling code to be configured.
( Step 1)
0 1
( Step 2)
or
0
( Step 3)
( Step 4)
( Step 5)
9
( )
If the number of digits of 0 is selected, the call code will correspond to that entered, for example, 125 followed by the code
*
106 will result in the call code 125106. This code corresponds to button 1 of the sound module.
Steps: Field +
7 Press "7" to select field "7".
Set an identification code (ID) for the access control module.
0
Note: Possible identification codes (ID): "000" to "999".
Press the key button to finish programming the field.
C Then press the number of the next field to configure or press the C button (cancel) to exit
or
programming mode.
Steps: Field + number of calling code digits + direct call + key button.
8
8 Press "8" to select field "8".
Set the number of digits in the calling code.
2 3
or
Enter one of the following options:
or
Field depth
( )
The above example shows the call code obtained if "125" is entered into the
numeric keypad.
Set the direct call: by entering a call code on the keypad if necessary or do not press the
1
or
key button to confirm.
Enter one of the following options:
"0" : Disable.
"1" : Enable.
Press the key button to finish programming the field.
C Then press the number of the next field to configure or press the C button (cancel) to exit
or
programming mode.
I D code + key button.
7 0 0 0
0 1 2 3
or or or
Column code
"3"
"2"
"1"
* "0"
0 1
or
Monitor code
"000" "125"
"001" "025"
"012" "005"
"125" "106"
89
C all code
"000125"
"001025"
"012005"
"125106"
Continued overleaf