golmar NEXA User Manual page 14

AUDIO AND VIDEO DOOR ENTRY SYSTEM - ACCESS CONTROL
MODULE PROGRAMMING
Programming fields:
Continued from previous page
Field "2": Changing special codes.
Allows the current code of the special codes to be changed (see p. 10). The new special code must have the same
number of digits as the current code.
Duplicate special codes are not allowed.
Note: Depending on the number of digits configured in field "0" (factory setting = 4).
Number of digits = 4, special codes from "0000" to "9999".
Number of digits = 5, special codes from "00000" to "99999".
Number of digits = 6, special codes from "000000" to "999999".
Steps
(Step 1)
0 1
(Step ) 2
or
0 0
(Step ) 3
(Step ) 4
3
(Step ) 5
: Field + special code
2 0
2
Press "2" to select field "2".
2 3 Set the special code to select for subsequent code changes. Enter one of the
or or
following
"0": Select the administrator pin.
"1": Select the CP1 button code.
"2": Select the CP2 button code.
"3": Select the unlock button
Set a new code number. Possible special codes: "000000" to "999999" with "6" digits.
0 0
Factory setting of "4" digits: "0000" to "9999" (see example of number of digits on p.
12, step 2).
Duplicate special codes are not allowed.
Press the key button to finish programming the
C
Then press the number of the next field to configure or press the C button (cancel) to exit
or
programming
+
1 2 3 0
or or or
options:
code.
mode.
code + key button
0 0 0
field.
14
.
Continued overleaf