How To Control The Unit; Master/Slave Function; Dmx Controller - ACME Theatre LED Colour Flood User Manual

4. How To Control The Unit

You can operate the unit in two ways:
1. By master/slave function
2. By DMX controller
You do not need to turn the unit off when you change the DMX address, the new DMX address
setting will take effect immediately.

4.1 Master/Slave Function

By linking the units in master/slave connection, the first unit will be master automatically. You
should set the master unit effect via its knobs, then the other units (slave) will lighting as the
same.

4.2 DMX Controller

If you use a universal DMX controller to control the units, you have to set DMX address from 1 to
512 so that the units can receive DMX signal.
Press the MENU button to enter menu mode, select DMX Functions, press the ENTER button to
confirm, use the UP/DOWN button to select DMX Address, press the ENTER button to confirm,
the present address will blink on the display. Use the UP/DOWN button to adjust the address from
1 to 512, press the ENTER button to store. Press the MENU button back to the last menu or let the
unit idle one minute to exit menu mode.
Please refer to the following diagram to set the address for the first 4 units.
Channel mode
4 channels
9 channels
Unit 1 Unit 2
Address Address
1
1
10B
Unit 3
Address
5 9
10 19
Unit 4
Address
13
28