Related Manuals for ACME CW-108
Summary of Contents for ACME CW-108
- Page 1 CW‐108 User Manual Innovation, Quality, Performance Please read the manual carefully before using...
-
Page 2: Table Of Contents
CONTENTS 1. Safety Instructions..................2 2. Technical Specifications................4 Declaration of Conformity 3. How to Set the Fixture ................. 5 We declare that our products (lighting equipments) comply with the following 3.1 Control Panel..................5 specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. -
Page 3: Safety Instructions
E. One of the channels is not working well 1. Safety Instructions 1. The stepper motor might be damaged or the cable connected to the PCB is broken. Please read the instruction carefully, it includes important 2. The motor’s drive IC on the PCB might be out of condition information about the installation, usage and maintenance. - Page 4 In the event of serious operating problem, stop using the unit immediately. Never try to 3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+) repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or 5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), malfunction.
-
Page 5: Technical Specifications
6. DMX 512 Connections 2. Technical Specifications ◇ Equipped with 36pcs of 3W R,G,B,W LEDs, creating powerful multi beam effect. ◇ Three Operation Modes: DMX, Master/Slave, Sound Active. ◇ DMX CH modes: 4/5/7CH selectable. ◇ Beam Angle: 13.5° ◇ Spectacular built-in programs under master/salve operation, triggered by music. ◇... -
Page 6: How To Set The Fixture
3. How to Set the Fixture 5. DMX 512 Configurations 3.1 Control Panel 4/5/7 channels mode: 1. Function Display: Show the various menus and the selected functions Function Button: 2. MENU To select the programming functions DOWN To go backward in the selected functions To go forward in the selected functions 5. -
Page 7: Main Function
14. DMX Output: For DMX512 link, use 3-pin XLR plug cable to link the next unit. Please refer to the following diagram to address your DMX512 channel for the first 4 units： 15. Only for remote control: Connect with CA-8 to control the unit for Stand by, Function and Mode function. - Page 8 control the others to give an automatic, sound activated, synchronized light show. This function is good when you want an instant show. Any fixture can act as a Master or as a Slave. 2-light show In slave mode, slave 1 means the unit works as master, slave 2 means 2-light show. In order to create a great light show, you can set the second unit to slave 2 to get contrast movement to each other, even if you have two units only.
-
Page 9: How To Control The Unit
DMX 512 Address Auto Test Select the , press the ENTER button and the display will blink. Use the DOWN and UP Select the , press the ENTER button and the unit will run the built-in programmer for button to change the DMX 512 address. Once the address has been selected, press the self-test. - Page 10 (Dimmer 255); select the (Color 10), press the ENTER button, and select the LED display Select the , press the ENTER button and the display will blink. Use the DOWN and UP (Red), (Green),… (Dimmer), pressing the ENTER button and adjust the button to select (LED display always on) or ( LED display off 20 seconds after...