Table of Contents
Advertisement
3. How To Control The Unit
(1) Master/Slave operation
The unit can be linked together in daisy chain as many as you need in
master/slave mode to perform the great built-in pre-programmed lighting shows
triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit: DMX start address MUST be set to 001. (first DIP switch = ON,
all other are OFF)
Slave units: DMX start address may have any value but NOT 001 (example:
set the first 3 DIP switches to ON)
＊ 2-light show
Dipswitch 10 "off" means the unit works normally and "on" means inversion. In
order to create a great light show, you can set dip switch 10 "on" on any unit that is
linking to the master unit to get contrast movement to the master unit, even if you
have two units only. Dipswitch 10 on the first ( Master ) unit is no use for the 2-light
show as it is the master unit that operates the light show.
(2) By easy controller
The easy remote control is used only in master/slave mode. By
connecting to the 1/4" microphone jack of the first unit (its DMX input
plug is not used), you will find that the remote control on the first unit
will control all the other units for Stand by, Function and Mode.
Built-in lighting shows triggered by Easy Controller:
Stand by
Blackout the unit
1. Sync. Strobe
Function
2. Sound Strobe
Sound
Mode
(LED OFF)
Select pattern
Pattern
(LED ON)
4-
Select Chase
Chase
(LED Slow Strobe)
Advertisement
Table of Contents
