How To Control The Unit; Dmx512 Configuration - ACME Diamonds LS-1010 RGB User Manual

SD Functions
Press the knob when the SD Functions show on the display, use the knob to select SD Mode, SD File or
Exit. Enter SD Mode, use the knob to select ILD Show, PRG Show or No SD, press the knob to confirm.
Enter SD File, select the file or folder, press the knob to confirm. Press EXIT to back to the menu.
Figure Functions
Press the knob when the Figure Functions show on the display, use the knob to select Size, Phase Set or
Exit. Enter Size, use the knob to select figure size from 10 to 100, press the knob to confirm. Enter Phase
Set, set the positon of the figure. Press EXIT to back to the menu.
Fixture Functions
Press the knob when the Fixture Functions show on the display, use the knob to select Back Lights,
Fixture Hours, Defaults, Version or Exit. Enter Back lights, use the knob to select on or off, press the
knob to confirm. Enter Fixture Hours, the running time of the unit will be show on the display. Enter
Defaults, use the knob to select Yes or no to restore factory settings or not. Enter Version, the version of
the software will be show on the display. Press EXIT to back to the menu.
5. How to Control the Unit
1. By ILDA;
Connect the unit to the computer with ILDA wire and control the software by computer laser;
Priority to control the unit: ILDA﹥DMX﹥Sound active﹥Auto play
2. By universal DMX controller;
Set the DMX address, the unit will be ready to receive DMX signal.
3. Sound active;
The unit will run show by the sound active.
4. Auto play;
The unit will auto play when no signal.
6. DMX512 Configuration
DMX Channel:
6A