Wall-Mounting; Stopping The Zywall/Usg - ZyXEL Communications ZyWall 110 User Manual

3.2.2 Wall-mounting

See Table 15 on page 54
attach your ZyWALL/USG to a wall.
Screw two screws with 6 mm ~ 8 mm (0.24" ~ 0.31") wide heads into the wall 150 mm apart (see
1
the figure in step 2). Do not screw the screws all the way in to the wall; leave a small gap between
the head of the screw and the wall.
The gap must be big enough for the screw heads to slide into the screw slots and the connection
cables to run down the back of the ZyWALL/USG.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the ZyWALL/USG with the connection cables.
Use the holes on the bottom of the ZyWALL/USG to hang the ZyWALL/USG on the screws.
2
Wall-mount the ZyWALL/USG horizontally. The ZyWALL/USG's side
panels with ventilation slots should not be facing up or down as this
position is less safe.

3.3 Stopping the ZyWALL/USG

Always use Maintenance > Shutdown > Shutdown or the shutdown command before you turn
off the ZyWALL/USG or remove the power. Not doing so can cause the firmware to become corrupt.
Chapter 3 Hardware, Interfaces and Zones
for the ZyWALL/USG models that can be wall-mounted. Do the following to
ZyWALL/USG Series User's Guide
55