Proxim ORiNOCO AP-700 User Manual page 28

Installation and Initialization
Initialization
Figure 2-12 Setup Wizard
Setup Wizard Instructions
1. Click Setup Wizard to begin. The Setup Wizard supports the following navigation options:
• Save & Next Button: Each Setup Wizard screen has a Save & Next button. Click this button to submit any
changes you made to the unit's parameters and continue to the next page. The instructions below describe how to
navigate the Setup Wizard using the Save & Next buttons.
• Navigation Panel: The Setup Wizard provides a navigation panel on the left-hand side of the screen. Click the
link that corresponds to the parameters you want to configure to be taken to that particular configuration screen.
Note that clicking a link in the navigation panel will not submit any changes you made to the unit's configuration on
the current page.
• Exit: The navigation panel also includes an Exit option. Click this link to close the Setup Wizard at any time.
CAUTION: If you exit from the Setup Wizard, any changes you submitted (by clicking the Save & Next button) up
to that point will be saved to the unit but will not take effect until it is rebooted.
2. Configure the System Configuration settings and click Save & Next. See
3. Configure the Access Point's Basic IP address settings, if necessary, and click Save & Next. See
Parameters for more information.
4. Assign the AP new passwords to prevent unauthorized access and click Save & Next. Each management interface
has its own password:
• SNMP Read Password
• SNMP Read-Write Password
• CLI Password
• HTTP (Web) Password
By default, each of these passwords is set to "public". See
5. Configure the basic Wireless Interface Configuration settings:
• Select the Operational Mode as follows and click Save & Next:
— 802.11a only mode: The radio uses the 802.11a standard only.
— 802.11b mode only: The radio uses the 802.11b standard only.
— 802.11g mode only: The radio is optimized to communicate with 802.11g devices. This setting will provide the
best results if this radio interface will only communicate with 802.11g devices.
— 802.11b/g mode: This is the default mode. Use this mode if you want to support a mix of 802.11b and 802.11g
devices.
System for more information.
Passwords for more information.
AP-700 User Guide
Basic IP
28