Using The Setup Wizard - Proxim ORiNOCO AP-700 User Manual

Installation and Initialization
Initialization
4. Enter the HTTP password in the Password field. Leave the User Name field blank. For new units, the default HTTP
password is public.
If you are logging on for the first time the Setup Wizard will launch automatically.
NOTE: To prevent the Setup Wizard from launching upon log in, click on Management > Services and choose
Disable from the Setup Wizard drop down menu.
5. Follow the steps below to configure the AP using the Setup Wizard (see
configure the system manually. Upon clicking Exit, the System Status screen will appear.
Figure 2-11 System Status Screen
The buttons on the left of the screen provide access to the monitoring and configuration options for the AP. See
Advanced Configuration
The Command Line Interface (CLI) also provides a method for monitoring and configuring the AP using Telnet or a
serial connection. For more information about monitoring and configuring the AP with the CLI, see
Interface (CLI).

Using the Setup Wizard

The first time you connect to an AP's HTTP interface, the Setup Wizard launches automatically. The Setup Wizard
provides step-by-step instructions for how to configure the Access Point's basic operating parameters, such as Network
Name, IP parameters, system parameters, and management passwords.
to begin configuring the AP without using the Setup Wizard.
AP-700 User Guide
Using the Setup Wizard), or click Exit to
Command Line
27