Proxim ORiNOCO AP-700 User Manual page 78

Advanced Configuration
Alarms
TFTP Trap Group
oriTrapTFTPFailedOperation
oriTrapTFTPOperationInitiated
oriTrapTFTPOperationCompleted
Image Trap Group
oriTrapZeroSizeImage
oriTrapInvalidImage
oriTrapImageTooLarge
oriTrapIncompatibleImage
oriTrapInvalidImageDigitalSignature
SNTP Trap Group
oriTrapSNTPFailure
oriTrapSNTPFailure
In addition, the AP supports these standard traps, which are always enabled:
RFC 1215-Trap
coldStart
linkUp
linkDown
Bridge MIB (RFC 1493) Alarms
New Root
topologyChange
All these alarm groups correspond to System Alarms that are displayed in the
that are sent by the AP to the SNMP managers specified in the
Alarm Host Table
To add an entry and enable the AP to send SNMP trap messages to a Trap Host, click Add, and then specify the IP
Address and Password for the Trap Host.
Trap Name
Trap Name
Trap Name
Trap Name
Trap Name
Description
TFTP operation failed
TFTP operation Initiated
TFTP operation completed
Description
Zero size image loaded onto device
Invalid image loaded onto device
Image loaded on the device exceeds the size
limitation of flash
Incompatible image loaded onto device
Image with invalid digital signature is loaded onto
device
Description
SNTP time retrieval failure
SNTP sync-up failure
Description
AP is on or rebooted
AP's Ethernet interface link is up (working)
AP's Ethernet interface link is down (not working) Informational
Description
AP has become the new root in the Spanning
Tree network
Trap is not sent if a newRoot trap is sent for the
same transition
Alarm Host Table.
AP-700 User Guide
System Status Screen, including the traps
Severity Level
Major
Informational
Informational
Severity Level
Major
Major
Major
Major
Major
Severity Level
Minor
Minor
Severity Level
Informational
Informational
Severity Level
Informational
Informational
78