Interface Parameters - Proxim ORiNOCO AP-700 User Manual

Command Line Interface (CLI)
Parameter Tables

Interface Parameters

Wireless Interface Parameters
The wireless interface group parameter is wif. For Single-radio APs, the wireless interface uses table index 3.
Common Parameters to 802.11a/b/g
Name
Wireless Interfaces
Table Index
Network Name
Auto Channel Select (ACS)* Integer
DTIM Period
RTS/CTS Medium
Reservation
MAC Address
Closed System
Wireless Service Status
Supported Frequency
Channels
Load Balancing Max Clients Integer
Distance Between APs
Antenna Diversity
* For 802.11a APs certified in the ETSI regulatory domain and operating in the middle frequency band, disabling Auto Channel Select will limit
the available channels to those in the lower frequency band.
†
Wireless Service Status cannot be shut down on an interface where Rogue Scan is enabled.
‡
Distance Between APs allows the AP to perform better in high noise environments by increasing the recieve sensitivity and transmit defer
threshold, as follows:
Distance Between
APs
Large
Medium
Small
Mini
Micro
Type
Group
Integer
DisplayString
Integer
Integer
PhyAddress
Integer
†
Integer
Octet String
‡
Integer
Integer
Receive Sensitivity Threshold
Value dBm
0 -96
9 -86
17 -78
25 -70
33 -62
Value
N/A
3
1 - 32 characters
My Wireless Network (default)
enable (default)
disable
1 - 255
1 = default
0 - 2347
Default is 2347 (off)
12 hex digits
enable
disable (default)
1 = resume
2 = shutdown
Depends on Regulatory
Domain
1 - 63
1 (large) (default)
2 (medium)
3 (small),
4 (minicell)
5 (microcell)
1 (Antenna 1),
2 (Antenna 2),
5 (Auto; both antennas)(See
Configure Antenna Diversity)
Transmit Defer Threshold
Value
33
33
43
53
59
AP-700 User Guide
Access
R wif
R index
RW netname
RW autochannel
RW dtimperiod
RW medres
R macaddr
RW closedsys
RW wssstatus
R suppchannels
RW lbmaxclients
RW distaps
RW atdiversity
dBm
-62
-62
-52
-42
-36
CLI Parameter
180