Proxim ORiNOCO AP-700 User Manual page 200

Command Line Interface (CLI)
Parameter Tables
Name
Policy Type
Priority Mapping Index
Apply QoS Marking
Table Row Status
* QoS must be enabled on the wireless interface before spectralink can be enabled.
† A priority mapping needs to be specified for a QoS Policy. The priority mapping depends on the type of policy configured. For Layer 2 policy
types (inbound or outbound) a mapping index from the 802.1p to 802.1D table should be specified. For Layer 3 policy types (inbound or out-
bound) a mapping index from the IP DSCP to 802.1D table should be specified. The mapping index, in both cases, depends on the number
of mappings configured by the user. For SpectraLink policy type a mapping is not required.
Specifying the Mapping between 802.1p and 802.1D Priorities
The QoS 802.1p to 802.1D Mapping Table specifies the mapping between 802.1P and 802.1D priorities.
Name
QoS 802.1p to 802.1D
Mapping Table
Table Index (Primary
Index)
802.1D Priority
(Secondary Index)
802.1p Priority
Table Row Status
Specifying the Mapping between IP Precedence/DSCP Ranges and 802.1D Priorities
The QoS IP DSCP to 802.1D Mapping Table specifies the mapping between IP Precedence/DSCP Ranges and 802.1D
priorities.
Name
QoS IP DSCP to 802.1D
Mapping Table
Table Index (Primary
Index)
802.1D Priority
IP DSCP Lower Limit
IP DSCP Upper Limit
Table Row Status
Type
Integer
†
Integer
Object Status
Row Status
Type
Table
Integer
Integer
Integer
Row Status
Type
Table
Integer
Integer
Integer
Integer
Row Status
Value
inlayer2,
inlayer3,
outlayer2,
outlayer3,
spectralink*
†
See Note .
enable
disable
enable
disable
delete
Value
N/A
0 - 7
0 - 7
0 - 7
enable
disable
delete
Value
N/A
0 - 7
0 - 7
0 - 62
1 - 63
enable
disable
delete
AP-700 User Guide
Access CLI Parameter
RW type
RW mapindex
RW markstatus
RW status
Access CLI Parameter
N/A qos1pto1dtbl
R index
R 1dpriority
RW 1ppriority
RW status
Access CLI Parameter
N/A qosdscpto1dtbl
R index
R 1dpriority
RW dscplower
RW dscpupper
RW status
200